Specifications - CTL Cold-Pour Two-Part Resin for Cable Joints

CTL resin cable joints

Features

Two-part Polyurethane resin in protective aluminium foil.
Mixing is performed in sealed conditions - no need for skin contact but safety gloves are provided.
Controlled curing temperature designed to be compatible with PVC, XLPE, EPR, Polythene and PILC cables.
Clear mixing instructions on every pack.
Full Health & Safety labelling.
Batch number & use-by-date on every pack.
Designed to meet the requirements of BS 6910, BS7888, CENELEC HD623 S1 and EN50393:2006.
The same well-proven high quality resin formula is used as standard throughout both the LV & MV ranges.

Specification
Mixed properties	Pack designed to contain factory dispensed quantities of resin & hardener
Specific gravity	1.40 Resin, 1.22 Hardener
Density (g/ml)	1.36 mixed system
Colour	Cream (standard)
Gel Time	20-30 minutes at 21º C for 200g mass
Peak Exotherm	54-75º C depending upon volume and ambient temperature.
Complete cure time	at 23º C - 24 hours at 80º C - 1 hour
Shelf life	24 months when stored at 5ºC - 15º C.
Operating temperature	-40º C to +100º C continuous, for cured product
Thermal Conductivity	>0.4w/mK
Tensile strength	45 MPa
Electrical strength	20kV/mm
Health & safety	Each pack contains mixing instructions and carries health and safety warnings. H&S (COSHH) Information Sheet available upon request
Transportation	No special labelling required for shipments by air, sea or road (UN No 2489, packaging group III)

Also available

Flame retardant, halogen-free resin to VO rating of UL94.
Traffic systems resin - Two-part, fast-curing toughened polyurethane resin designed for the encapsulation of speed sensors, junction boxes and the bases of control cabinets.
Re-enterable resin - Two-part polyurethane resin that can be removed after curing. Ideal for encapsulating expensive components or multicore and multipair cables where subsequent repair may be required.